Seagate ST3500641AS Manuel d'utilisateur

SeriTek™/2SE4 Four External Port Hot-Swap Serial ATA PCI-X Host Adapter With Port Multiplication User Manual for Macintosh

7III. Connecting External Enclosure(s) Introduction This section describes how to connect external hard drive enclosures and a method of formatting

8 Figure 3: Using SeriTek/2SE4 with a drive enclosure that has I-shaped eSATA connectors; both cable connectors will be identical.

92. After finalizing your new storage configuration click Done, or Show Diagnostic Details: If you click Done and if there are any unformatted st

10 Figure 6B: Three peripherals are attached to the port multiplier Figure 6C: Channel 3, Unit 1 is a Seagate ST3500641AS configured at 1.5Gbit/sec

11 Figure 6: Disk Insertion Window Formatting Serial ATA Drives Using Macintosh OS X Version 10.4.0 or Later Turn on your Macintosh computer. 1. O

122. Review the list of hard drives show within Disk Utility (see Figure 8). Drives currently in use should have a list of volume names below it.

13Creating a RAID Volume with Serial ATA Hard Drives Using Macintosh OS X version 10.4.0 or Later are depicted, Mac OS X versions 10.2.0 or Later ar

14 Figure 12: Example drives and options for a RAID volume; Drag and Drop Drives into the RAID Set Window 6. Repeat step 5 for each member for th

15 Figure 14: Creating a new RAID volume 11. After the RAID volume is successfully initialized, it should appear on the desktop.

16IV. Using SeriTek/2SE4 Hot-Swap Functionality Introduction The SeriTek/2SE4 host adapter provides advanced hot-swap functionality which provides f

FirmTek, LLC www.firmtek.com Copyright Copyright © 1999-2007 FirmTek, LLC. All rights reserved. No part of this manual may be reproduced, transl

17 Figure 16: Example Serial ATA hard drive connected to channel 0 Removing External Hard Drive(s) Caution: To prevent loss of data, save your wo

18 Figure 18: Connecting External Hard Drive(s)

19V. Troubleshooting • The SeriTek/2SE4 host adapter does not seem to be recognized Check the SeriTek/2SE4 adapter by ensuring it is properly seate

20peripheral. How can I set it to Master or Slave; is there any way to set the SCSI ID? Serial ATA hard drives and peripherals are internally confi

21Return Merchandise Authorization If FirmTek technical support determines the product needs to be repaired or replaced, a Return Merchandise Author

22 VIII. Regulatory Compliance Statements Federal Communications Commission Radio Frequency Interference Statement WARNING: Changes or modificati

23

iii TABLE OF CONTENTS I. Introduction……. ... 1II. Installin

I. Introduction Welcome Congratulations and thank you for purchasing the SeriTek/2SE4 Serial ATA host adapter. This product is yet another innovati

2SeriTek/2SE4 Package Contents • SeriTek/2SE4 Serial ATA host adaptor board • CD-ROM Containing the Macintosh User Manual SeriTek/2SE4 Key Featur

3 SeriTek/2SE4 Specifications Hardware Requirements • PCI-X based Macintosh with available PCI-X expansion slot Operating Systems Supported •

4SeriTek/2SE4 System Requirements Operating System • Macintosh OS X version 10.4.0 or later Hardware Requirements • PCI-X based Macintosh with

5II. Installing the SeriTek/2SE4 Caution: Prior to installing the SeriTek/2SE4 host adapter and hard drive(s) or peripheral(s), please make sure yo

6 Figure 1: Inserting and securing the SeriTek/2SE4 8. Close your Macintosh computer case and re-attach the AC power cord. Ready for Use Your S