Seagate ST32430N/ND Manuel de service

1Series 700 Workstation to B–Class Workstation Upgrade ProceduresPart No. A4190–90013Edition E1096Hewlett–Packard Company3404 East Harmony Rd., Fort

10NOTICE:SCSI ID612345SecondDrive5Seagate Disk Drive Models – ST32430NNOTICE: A0, A1 are the SCSI ID jumpers. Thejumpers

11CD ROM Drive HP Part Number A4325–60001 or A3416–60001TargetIDJumpersSCSI-2 Terminators(must be removed)DefaultSCSI ID 6 is the default for root and

123. EISA CardsTo remove and replace any of EISA cards, perform the following:A. To remove an EISA card from your Series 700 system refer to your Ser

135. Install the B–Class WorkstationInstall the B–Class workstation according the Hardware Installation Card, B–Class (HP part#A4190–90010)6. Install

14Part Number: A4190–90013Printed in U.S.A.Edition E1096

2 Hewlett-Packard Co. 1996First Printing: October 1996UNIX is a registered trademark in the United States and other countries, licensed exclusively t

3Emissions RegulationsFederal Communications Commission (FCC)The Federal Communications Commission of the U.S. government regulates the radio frequenc

4 Warnings and CautionsWARNING:Removing device cover may expose sharp edges in equipmentchassis. To avoid injury, use care when installing customer

5700 Series Workstation to B–Class Workstation Trade–UpInstallation Instructions.These instructions document the installation of a B–Class workstation

6Upgrade OverviewAn overview of the 700 Series to B–Class Workstation Trade–up Installation procedures are shown in thefollowing flowchart. Depending

7Supported Series 700 ComponentsThe components you can use from the Series 700 workstation are described in Table 1Table 1 Components Supported in th

8Powering Down Your Series 700 WorkstationBefore you power down your Series 700 workstation, check the type of graphics cards in your system bytyping:

92. Internal Storage DevicesTo remove and replace the internal storage devices perform the following:A. To remove an internal storage devices from yo