Seagate MEDALIST PRO ST36530N/W/WC Manuel d'utilisateur télécharger pdf (Page 46)

44 Medalist Pro Installation Guide, Rev. B

N drives

Terminator power

There are four possible terminator power (

) configurations for

“N” model drives (see Figure 9). You will not normally need to

change this option and can leave the drive configured as it was

shipped from the factory.

Figure 9. Setting terminator power jumpers

Drive supplies term. power to SCSI bus only

Drive supplies term. power for its own terminators only (default)

“N” model drives

Drive supplies term. power for its own terminators

and drive supplies term. power to SCSI bus

Drive takes term. power from SCSI bus

Position A

SCSI I/O

Connector

DC Power

Connector

Drive

Front

J2 Jumper Type

(enlarged to

show detail)

Pin 1

Note: TP jumper(s) must

always be in one of the

configurations shown,

even if TE jumper is

not installed.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 59 60

Pas de commentaire

Seagate MEDALIST PRO ST36530N/W/WC Manuel d'utilisateur Page 46