Seagate ST336704FC Guide d'installation télécharger pdf (Page 17)

Chapter 1: HP Clustered File System Commands 11

-H, --hard

Perform a hard, immediate stop of the HP Clustered File System

processes. mxinit first attempts to terminate any applications

accessing PSFS filesystems. It then unmounts the filesystems,

terminates the HP Clustered File System processes, and unloads HP

Clustered File System modules.

-L, --load-mod

Load all HP Clustered File System modules.

-U, --unload-mod

Unload all HP Clustered File System modules.

-f file, --alt-config-file file

Use the specified configuration file instead of the default

configuration file (/etc/hpcfs/mxinit.conf).

-v, --verbose

Print verbose output about each step of the mxinit operation.

--version

Display the version of HP Clustered File System.

-m, --monitor

Explicitly tell mxinit to monitor processes. This is the default when

mxinit is invoked to start HP Clustered File System.

-M, --no-monitor

Explicitly tell mxinit not to monitor processes.

--hba-status

Display the state of the FibreChannel host bus adapter drivers.

--status

Display the status of HP Clustered File System processes and

modules. Following is an example.

$ status

HP Clustered File System Status:

Name pid / status

mxinit 15930 mxinit: Monitoring MxS processes

mxlog Loaded

grpcommd 15885

mxlogd 15887

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 76 77

Pas de commentaire

Seagate ST336704FC Guide d'installation Page 17