Seagate ST3300007LW Guide de l'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 89
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
SCSI Hammer™ Users Guide
Page 28 of 89
Settings
Menu Tree
The user may set options that will customize
certain SCSI Hammer™ functions. User selected
parameters within the Settings menu are stored in
non-volatile memory and may be reset to factory
defaults using the ‘Restore Defaults’ submenu
item, if desired.
Each of the ‘Settings’ submenus are described in
detail in the following section.
|========================
|SETTINGS
|--------POWER ON TIMEOUT
|--------|-----POWER ON TIMEOUT
|--------|-----|--<SELECT TIME IN MS>
|--------COMMAND TIMEOUT
|--------|-----TIMEOUT COUNT
|--------|-----|--<SELECT TIME IN MS>
|--------RETRY COUNT
|--------|-----<SELECT RETRY COUNT>
|--------BUS ID
|--------|-----<SELECT BUS ID>
|--------BLUETOOTH T.O.
|--------|-----|--<SELECT TIME IN MS>
|--------CONNECTION TEST
|--------CLOCK/CALENDAR
|--------BUZZER
|--------|-----ENABLED
|--------|-----DISABLED*
|--------SESSION NUMBER
|--------|-----DISPLAY SESSION
|--------|-----RESET SESSION
|--------RESTORE DEFAULTS
|========================
Default: See individual listings below
SCSI Hammer™ Settings Submenus
|========================
|SETTINGS
|--------POWER ON TIMEOUT
|--------|-----POWER ON TIMEOUT
|--------|-----|--<SELECT TIME IN MS>
Power on Timeout
Default: 20,000ms (20 seconds)
This value defines the maximum time SCSI Hammer™ will wait for a drive to come
ready on power-up. While this value is typically sufficient for healthy drives, users may
wish to increase this value for drives with errors.
This does not mean that every power-up sequence will take the full Power on Timeout
period, as Hammer™ will continue as soon as a drive comes ready.
|========================
|SETTINGS
|--------POWER ON TIMEOUT
|--------|-----POWER ON TIMEOUT
|--------|-----|--<SELECT TIME IN MS>
|--------COMMAND TIMEOUT
|--------|-----TIMEOUT COUNT
|--------|-----|--<SELECT TIME IN MS>
Command Timeout
Default: 4,000ms (4 seconds)
This value defines the time SCSI Hammer™ will wait, after a command has been issued,
for an attached drive to respond. Drives which do not respond to a command within the
time allotted here will generate a timeout error.
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 88 89

Commentaires sur ces manuels

Pas de commentaire