Seagate ST15150N - Barracuda 4.3 GB Hard Drive Manuel d'utilisateur télécharger pdf (Page 29)

5 REAR PANEL CONNECTIONS

Analog Audio These XLR connectors are the balanced analog audio inputs and outputs.

Pin 2 is hot (+), pin 3 is cold (-), and pin 1 is ground.

Digital Audio Optional on the V1 and V1b and standard on the V1D. Transformer

balanced AES/EBU input and output. Pin 2 is hot (+), pin 3 is cold (-),

and pin 1 is ground.

RS-422 (1) The serial interface connector to the V1. Connector 1 should be

connected to your edit controller or workstation, while connector 2 is

used to connect the optional RCV1 external remote control from Doremi

Labs, Inc.

RS-422 (2) or Biphase If the internal cable of RS-422 connector-2 is installed on J10 of the

main motherboard, this port can be used as a second RS-422 connector.

It can then be used to connect the optional RCV1 external remote

control from Doremi Labs, Inc. If the internal cable of RS-422

connector-2 is installed on J3 of the main motherboard, this port can be

used as the Biphase input connector. Refer to Section 4.1, "Hardware

setup of the Biphase Input".

J1 DIP switches for selecting the SCSI ID of the V1. See Section 0, "DIP

Switch Settings".

Time Code Balanced TRS 1/4" input and output connectors for LTC time code. The

V1 time code input accepts balanced signals (tip hot, ring cold & sleeve

is ground). If you are feeding an unbalanced signal to it, both ring and

sleeve should be connected to GND. You can use an unbalanced jack

(tip and sleeve) on the time code input of the V1. The V1 time code

output is a balanced signal (tip hot, ring cold & sleeve is ground). If you

are feeding it to an unbalanced input, ring should not be connected to

anything. You can not use an unbalanced jack (tip and sleeve) on the

time code output of the V1. If you connect time code from one V1 to

the other the cable should be balanced on both ends.

Sync In House Sync input BNC connector for the V1 synchronization reference.

Use only Black Burst Sync here. Your Sync input should not exceed 1V

P-P.

Video Analog Composite video input and output BNC connectors. Video IN is

where you connect your video signal for recording to the V1 and Video

OUT is for connection to a video monitor or another video recorder.

S-Video Mini DIN-4 connectors for S-Video (Y/C) input and output.

SDI V1D only. Serial Digital Interface input and output BNC connectors for

a direct connection with digital betacams.

RGB/YUV V1D only. Three RGB or YUV selectable BNC output connectors

SCSI Standard 50-pin female Centronics connector for connection to external

SCSI drives. When no external SCSI devices are used, make sure the

supplied terminator is connected here. When connecting external drives,

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 68 69

Pas de commentaire

Seagate ST15150N - Barracuda 4.3 GB Hard Drive Manuel d'utilisateur Page 29