Seagate ST15150N - Barracuda 4.3 GB Hard Drive Manuel d'utilisateur télécharger pdf (Page 58)

13 INSTRUCTIONS FOR INITIAL SETUP & TRANSPORT

IMPORTANT !!

♦ Before powering-up the V1 unit, please connect the SCSI termination supplied on the rear

external SCSI connector (If not there, the V1 will not operate properly).

♦ After powering-up, if your V1 has been ordered with a drive from Doremi Labs, you will be able to

play the initial "video test" recording (In NTSC for USA, PAL for Europe) without the need of an

external sync reference (Internal Sync. selected). If you need to play locked to House Sync, connect

a Black Burst signal to the SYNC IN connector and go to menu (02) "Sync from", select the option

Sync In and validate by pressing ESC.

♦ Before turning the V1 OFF, please eject all JAZ cartridges

♦ Before any transport :

♦ Please eject

all JAZ or MOD cartridges and remove them.

♦ Lock the Data-Express (Key ON as for normal use).

♦ Switch the V1 OFF.

♦ Remove

the SCSI termination on rear (Leaving it may break the SCSI connector during

transport ).

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 68 69

Pas de commentaire

Seagate ST15150N - Barracuda 4.3 GB Hard Drive Manuel d'utilisateur Page 58