Seagate ST3500641AS Manuel d'utilisateur télécharger pdf (Page 8)

II. Installing the SeriTek/2SE4

Caution:

Prior to installing the SeriTek/2SE4 host adapter and hard drive(s) or peripheral(s), please

make sure your data is backed up.

The SeriTek/2SE4 host adapter and your Macintosh contain sensitive components that can

be permanently damaged by Static Electric Discharge. Be sure you’re working in an area

free of static electricity to prevent them from being damaged. Use a wrist grounding strap if

you have one or regularly touch a metal part of the computer chassis such as the power

supply case or a port access cover to discharge any built-up static electricity from your body.

Make sure to handle the SeriTek/2SE4 host adapter by its bracket or around its edges to

avoid damage to the card by static electricity.

Introduction

This section describes the proper method of installing your SeriTek/2SE4.

SeriTek PCI-X Host Adapter Installation:

1. Properly shut down your Macintosh and disconnect the AC power cord.

2. Depending on the model of your Macintosh, open the side panel or top cover. On some

models, you may need to open a plastic cover to access the PCI-X slots. Please refer to

your Macintosh user manual for more information about gaining access to PCI-X slots.

3. Choose an empty PCI-X expansion slot where you will install the SeriTek/2SE4.

4. Remove the screw and detach the PCI-X expansion port access cover secured to the

computer case.

5. Remove the SeriTek/2SE4 from its protective materials. Make sure to hold the card

around by its bracket or around its edges to avoid touching components which might be

damaged by static electricity.

6. Position the PCI-X card bracket by facing it towards the rear of the computer. Align the

gold connectors of the SeriTek/2SE4 over the PCI-X slot and gently press it into the PCI-

X slot until the card is firmly seated. If the card is properly seated, the upper ear of the

PCI-X card bracket should line up with the screw mounting location.

7. Using the same screw that was removed earlier; secure the card to the Macintosh

computer case (see Figure 1).

Caution: The SeriTek/2SE4 host adapter supports external cables that may be plugged

in to one of their external receptacles. If the SeriTek/2SE4 is not properly secured when

a cable is inserted into one of the receptacles, it may become loose from the PCI-X slot and

damage the computer.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Pas de commentaire

Seagate ST3500641AS Manuel d'utilisateur Page 8